THE RME VENTING AND COMBUSTION AIR SOLUTION:

Click on the logo for all the information you will need to make a logical boiler choice

 

 

 

 

 

 

Engineered Fully Modulating Chimney Automation Systems, Fully Modulating Combustion Air Systems, In line and termination fans, Modulating dryer venting systems, fireplace and grease fans. 

 

The highest quality most accurate venting specialist in your area.  In fact, we guarantee our performance in writing and our product for two full years!

 

Highest quality positive pressure chimney manufacturer.  Fully engineered with drawings.  Also specializing in pre engineered one piece stacks.  Double wall with air space or up to 4" of insulation.  UL approved grease duct systems.

 

 

Energy is the key and Kentube can recover you vent waste with the most innovative condensing stack economizers on the market.  Not your typical water tube economizers!  Kentube specializes in firetubes and uses this non flow reliant design to insure you are capturing the most wasted heat while taking advantage of a design that is sure to out last the competition!

For your large volume industrial combustion air applications let Rapid design the air handler.
Text Box:  When you think of venting think of Roberts Mechanical.  No other rep can offer you the expertise in optimizing your venting system to make the appliances run at their peak efficiency. We have the ability to review any of your venting designs and determine of chimney automation can effectively save your customer design dollars by shrinking your common vent size and guaranteeing draft performance required by your specific appliance. We will check your design for code violations and potential draft problems and provide you a complete report to assist you in your design. In addition we can provide a modulating combustion air system which will bring in ONLY the air your appliance needs and eliminate large louvers and motorized dampers!  Save energy and first cost by finishing off your design with Schebler positive pressure vent material and Kentube stack economizers!  Who else can offer you all of this under one roof?  All supported by our in house factory trained service group.  Single point responsibility will be your best friend when it comes to venting and combustion air!   

Roberts Mechanical Equipment Company directly represents all listed manufacturers under an exclusive representative agreement.  Pricing from RME on both new equipment and replacement parts is factory direct.  If you are interested or own any of these products contact us to gain the most competitive position in our market place.